Special products for construction industry
Waterproofing - Damp Proofing
Resin Floors
Glossy Waterproof Coating for Cotto Tiles
NORDCOTTO W LUX is an emulsion formulation that, once applied to cotto floor tiles or to any other natural absorbent material (stone, wood, etc..), makes it waterproof adding a high gloss finish at the same time.
NORDCOTTO W LUX is usually used as an aesthetic and waterproofing treatment for cotto tiles and other absorbent materials laid on the floor, where a slightly toned and very uniform high gloss effect is required.
NORDCOTTO W LUX, being part of the eco-friendly treatment range "ECOLOGIC LINE", is chosen by those who prefer using solvent-free materials of very little environmental impact for a final cotto tiles finishing work.
NORDCOTTO W LUX is available in 1, 5 and 25 liters containers.
Glossy Waterproof Coating for Cotto Tiles
On a floor laid at least 30 days before, perfectly dry and clean, apply two coats of NORDCOTTO W LUX and allow at least 6 hours in between each coat.
Any treated surface is perfectly walkable after 24 hours at 20°C.
The best method of applying NORDCOTTO W LUX is by far to use a wax applicator MOP, to prevent the formation of excessive foaming in the finishing phase.
On large areas, the application can be carried out using a low pressure sprayer followed by a once-over with a wax spreader.
Glossy Waterproof Coating for Cotto Tiles
Average coverage: 0.15 liter/m2.
Glossy Waterproof Coating for Cotto Tiles
bulk density, UNI 8310 |
g/cm3 |
1.05 ± 0.05 |
apparent dynamic viscosity, ISO 3219 |
mPa·s |
20 ± 5 |
superficial exsiccation time, UNI 8904 |
min |
30 ± 5 |
application temperature |
°C |
from +10 to +30 |
Note: testing methods are in accordance with the standards referred to on the table.
Glossy Waterproof Coating for Cotto Tiles
The product is not dangerous, nonetheless a Material Safety Data Sheet is available.
Store in a covered place, at room temperature between +4 and +30°C.