DEKOR-SEAL CLEANER

Alkaline Hard Surfaces Cleaner

Description

DEKOR-SEAL CLEANER is a concentrated alcohol-based alkaline cleaner specifically formulated for hard surfaces. DEKOR-SEAL CLEANER removes unpleasant odours from the surface with a lemon scent conferring a fragrance that is permanent but still light. At given dilution rate, DEKOR-SEAL CLEANER does not foam and consequently there is no need to rinse with any industrial floor cleaning machines.

Usage field

DEKOR-SEAL CLEANER is a product specifically developed to clean surfaces treated with DEKOR-SEAL S500, DEKOR-SEAL S500 OPACO.

Since DEKOR-SEAL CLEANER action does not damage the wax, this product is also ideal for use over floors treated with DEKOR-SEAL WAX.

Due to the absence of solid residues deposited on the surface, DEKOR-SEAL CLEANER is also ideal for cleaning floors on which NORPHEN ESC cycle or other antistatic / conductive products have been applied .

Generally, this product can also be used for cleaning epoxy resins and polyurethanes coated surfaces.

Packaging

1 and 5 liters PE containers 

DEKOR-SEAL CLEANER

Alkaline Hard Surfaces Cleaner

Application

On surfaces previously treated with DEKOR-SEAL S500 or DEKOR-SEAL S500 MAT or other resin treatments

When used to clean surfaces previously treated with DEKOR-SEAL S500 and DEKOR-SEAL S500 OPACO or resin coated, DEKOR-SEAL CLEANER should be diluted with water in a ratio of between 1:5 and 1:20 by volume (1 litre of product every 5 or 20 litres of water) depending on the type and amount of dirt. For large areas a mono-brush equipped with a white disc or an industrial floor cleaning machine (also scrubber dryers machine)can be used. Other types of disc can be used, but their effectiveness should be checked first to avoid damaging the coating. It is recommended to rinse with water at the end of the treatment.

 

Preliminary cleaning prior to the application of Dekor-SEAL WAX

Prior to the application of DEKOR-SEAL WAX, the surface must be thoroughly cleaned with DEKOR-SEAL CLEANER diluted 1:1 with hot water (1 litre of DEKOR-SEAL CLEANER in 1 litre of warm water) with a mono-brush equipped with a white disk. Rinse with water, preferably warm, and allow to dry for at least 1 hour removing any standing water. Apply DEKOR-WAX SEAL according to the instructions given in the technical Data Sheet.

Surfaces protected with DEKOR-SEAL WAX

DEKOR-SEAL WAX treated surfaces can be washed with DEKOR-SEAL CLEANER diluted with water volumetric ratio ranging from 1:10 to 1:20 (one litre of product in 10 or 20 litres of water) depending on the type and amount of dirt. No need to rinse. An industrial floor cleaning machine or scrubber dryers machine can be used.

Substrates preparation

DEKOR-SEAL CLEANER coverage varies according to the used dilution. The product can be used pure or diluted with water up to 1:20.

Specific preparation
  • The product is not hazardous to health, however, refer to MSDS before use.
  • Keep the product away from heat and direct sunlight, store it in a dry place.
Product conditions of application

density (at 20 ± 3 ° C), UNI 8310

g / cm ³

0.998 ± 0.005

pH, UNI 24003

-

9.50 ± 0.08

Appearance

-

 sunset yellow opalescent liquid 

Odor/Smell

-

lemon

dry residue (at 105 ° C, 1 hour)

%

3.7 ± 0.1

Note: testing methods are in accordance with the standards referred to in the table.

DEKOR-SEAL CLEANER

Alkaline Hard Surfaces Cleaner

Preservation

24 months in original packaging, in a covered, dry area at temperatures between +5 ° C and +35 ° C. Frost sensitive.