AM PRIMER

Disinfectant, Anti-Mildew and Seaweed Agent for Building Surfaces

Description

AM PRIMER is a ready to use water-based liquid mixture to be laid over any substrate infested with algae and mildew before application of paints and wall coverings.

This product exerts a very effective disinfectant, anti-mildew and algae action.

Usage field
  • INDOORS: on ceilings, walls and masonry walls, fibre cement, plasterboard and painted or unpainted wood.
  • OUTDOORS: on any absorbent surface subject to any kind of algae infestation phenomena.

AM PRIMER does not prevent anchoring of the subsequent coating layers.

Packaging

1 and 5 liters plastic containers 

AM PRIMER

Disinfectant, Anti-Mildew and Seaweed Agent for Building Surfaces

Application

The product is ready for use: Shake the container prior to withdrawing.

Keep in mind that in the case of areas with small infested areas it is not recommended to act only on the polluted part, but it is preferable to operate on a much wider area.

  • Apply a small amount of AM PRIMER with a roller or flat brush or sprayer to the area to be treated (protecting the respiratory tract with a mask providing protection from gases and vapours of organic compounds like A1B1E1K1P3);
  • allow a few hours (3-4 are usually enough) for the product to act and then proceed with the cleaning of the treated area using an abrasive sponge;
  • apply another generous coat of AM PRIMER if the surface is sound (two or three coats in case of a clearly deteriorated surface) at intervals of half an hour from each other;
  • once the surface is fully dry (usually 4-6 hours), proceed with the subsequent painting treatment.

AM PRIMER

Disinfectant, Anti-Mildew and Seaweed Agent for Building Surfaces

Features

Bulk Density, UNI 8310

g/cm3

0.99 ± 0.005

pH, ISO 976

---

7.6 ± 0.4

Apparent dynamic viscosity (ASTM spindle 1, 150 RPM), UNI EN ISO 2555

mPa·s

60 ± 5

Stability Interval

°C

from -10 to +50

Note: the test methods refer to the related standards as shown in the table.

 

AM PRIMER

Disinfectant, Anti-Mildew and Seaweed Agent for Building Surfaces

Warning and informations
  • Avoid applying AM PRIMER to surfaces where diluted sodium hypochlorite (bleach) or chlorine-based compounds have been used as disinfectants.
  • In case of outdoors application, protect from rain in the first 12÷24 hours after application.
  • Avoid contact with eyes and skin.
  • In case of skin contact, wash affected area of skin thoroughly with soap and water and then rinse with water.
  • Contaminated clothing should be immediately removed and washed. 
Preservation

24 months in original packaging, in a covered and dry place. At temperatures ranging from +5 ° C to +35 ° C.